Use this guide to find the perfect size for your PIAGET jewelry.
PIAGET rings
Follow these tips to measure your ring size:
- Measure your finger in the evening,
- Do not measure your finger in extreme heat or cold,
- Measure the correct hand, our fingers are not the same size on the right hand and left hand,
- Make sure your ring can comfortably travel the full length of your finger in your chosen size.
Check that the document was printed correctly by measuring the sample below using a ruler. It must measure exactly 2 cm.
- Cut out the paper measure opposite.
- Cut a slot following the instructions “CUT A SLOT HERE”.
- Make sure the numbers are on the outside of the measurer.
- Insert the pointed end into the slot you cut.
- Insert your finger and pull the pointed end to the desired result for a comfortable and snug fit.
- The number aligned on the cut-out slot indicates your finger size.
In the case of a Possession ring with a ring width greater than 6 mm, if your finger size is between 2 sizes, we recommend that you choose the larger metric.
The Piaget finger measurer is given for information purposes only and cannot under any circumstances be used as an exact guide to the choice of ring size.
If you have a ring that fits perfectly on the finger on which you will wear your Piaget creation, you can place it on the circle whose diameter fills the inside of your ring. The inner edge of your ring should line up with the outer edge of the circle.
If your ring is between two sizes, Piaget recommends choosing the larger one.
In the case of a Possession ring, whose ring width is greater than 6 mm, if your finger size is between 2 sizes, we recommend that you take the larger size.
To choose the best option for your Piaget piece, refer to this table after taking the necessary measurements.
A precise measurement of your wrist will ensure the best comfort.
Follow these few steps to best measure your bracelet size:
- Wrap a measuring tape around the wrist you plan to wear your bracelet on.
- Take our measurement: this is your bracelet size.
- Wind a ribbon or piece of rope and measure the length with a ruler.
- Add 1.5cm to ensure the bracelet fits you comfortably.
You can add or remove inches depending on your preference: loose, exact or tight.
KNOW YOUR BRACELET SIZE USING THE PIAGET MEASURER
Check that the document was printed correctly by measuring the sample below using a ruler. It must measure exactly 2 cm.
- Cut out the paper measure opposite. Cut a slit following the instructions "CUT A SLOT HERE".
- Make sure the numbers are on the outside of the measurer.
- Insert the pointed end into the slot you cut.
- Insert your wrist and pull the pointed end according to the desired look on your wrist, for comfortable, more or less fitted wear.
The number aligned with the cut-out slot indicates your wrist size.
You can also use a meter or, failing that, a ribbon or cord. Wrap it around your wrist and measure the length using a ruler.
TO CHOOSE THE SIZE OF A CLOSED BANGLE BRACELET :
The measurement system is different for closed bangle bracelets.
Ideally, we recommend that you go to our MAIER Joaillier store to find the size that suits you. Our team is at your disposal for any questions on 04 72 04 90 50 or at contact@maier-joaillier.fr.